Wiring Blade 400 RTF

by Michael Burke
(Galway, Ireland)

I'm connecting the wires on my Blade 400 to the AR6200 receiver, I have all the wires connected up except the tail servo - where does it plug in?
This is a pre-owned heli RTF, my rx is a Spektrum DX6i which bought separately.

Comments for
Wiring Blade 400 RTF

Click here to add your own comments

Mar 28, 2011

Re: Wiring Blade 400 RTF
by: Pete

Hi Michael - the rudder servo plugs in to the gyro and the gyro plugs in to the RUDD slot of the receiver. The yellow wire with the separate connection doesn't need to be connected to the Rx unless you want auxiliary gyro gain control from the transmitter. I wouldn't recommend that though, it's safer to adjust the gyro gain manually on the ground if you need to, until you're confident in the air.

If you're new to this type of helicopter then I can recommend the Setup and Tips for 400 Size RC Helicopters ebook, it has all the info that you'll need.

Click here to add your own comments

Go to rc-airplane-world.com home page.

Site search:

Translate this page:

Like this site:

Pete's ebooks

The Beginner's Guide To Flying RC Airplanes is the ebook to buy if you're just getting in to rc airplanes. Step-by-step guidance on starting out in this fun, exhilarating & addictive hobby, written by Yours Truly. Great value at just $12.95!

Beginner's Guide To Flying RC Helicopters is the follow-up to the rc airplanes ebook - the ultimate 'getting started' heli guide, for just $14.95!

Or...
Buy both ebooks together, save 20%! buy both together and save 25%!